BNLCC - EVERGLASS, A622
- MSDS: BNLCC
- Manufacturer: FIBRE GLASS EVERCOAT CO INC
- Product Name: EVERGLASS, A622
- National Stock Number: 8030-00N026686
Product Identification
Product ID:EVERGLASS, A622
MSDS Date:10/09/1990
FSC:8030
NIIN:00N026686
MSDS Number: BNLCC
Responsible Party
CINCINNATI, OH 45242
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 800-729-7600
Preparer: JEFF ZYCH
Cage: 18731
Contractor
Telephone: 513-489-7600
Cage: 18731
Ingredients
FIBROUS GLASS; (GLASS FIBERS)
CAS: 65997-17-3
Fraction By Weight: <5%
OSHA PEL 5 MG/M3 (MFR)
ACGIH TLV: 10 MG/M3
5.0 @ 68F
CAS: 100-42-5
RTECS: WL3675000
Fraction By Weight: 15.76%
OSHA PEL 100 PPM
ACGIH TLV: S,50PPM/100STEL;9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
POLYESTER RESIN
Fraction By Weight: 25%
TALC (POWDER), CONTAINING NO ASBESTOS FIBERS
CAS: 14807-96-6
RTECS: MW2700000
Fraction By Weight: 55%
OSHA PEL 2 MG/M3 RDUST
ACGIH TLV: 2 MG/M3 RDUST
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE/CHRONIC: INHALATION OF REPEATED
HIGH CONC MAY CAUSE LIVER/KIDNEY DAMAGE. INHAL:VAPORS MAY CAUSE
NOSE, THROAT & RESPIRATORY TRACT IRRITATION. HIGH CONC MAY CAUSE
HEADACHE & NAUSEA. SKIN:PROLONGED /FREQUENT CONTACT MAY CAUSE
DEFATTING, DRYNESS W/IRRITATION & POSSIBLE DERMATITIS. EYE:MAY
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE: GROUP 2B (IARC)
Effects of Overexposure:HLTH HAZ:CAUSE TEARING & IRRITATION. ABSORPTION
MAY CAUSE DERMATITIS & IRRITATION. INGEST:MAY CAUSE
GASTROINTESTINAL DISTURBANCES, PAIN & DISCOMFORT.
Medical Cond Aggravated by Exposure:LIVER & KIDNEY DISORDERS.
First Aid
First Aid:SKIN:WASH W/SOAP & WATER. EYE:FLUSH W/WATER FOR AT LEAST 15
MINS & GET MEDICAL ATTENTION. INHAL:REMOVE VICTIM FROM EXPOSURE. IF
UNCONSCIOUS, GIVE ARTIFICIAL RESPIRATION OR OXYGEN AS NEEDED. GET
MEDICA L ATTENTION. INGEST:DO NOT INDUCE VOMITING (ASPIRATION
HAZARD). GET MEDICAL ATTENTION.
Fire Fighting
Flash Point Method:CC
Flash Point:98.0F,36.7C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL & WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:IF CONTAINED, VIOLENT RUPTURE MAY RESULT.
POLYMERIZATION MAY TAKE PLACE AT ELEVATED TEMPERATURE SUCH AS IN A
FIRE.
Accidental Release
Spill Release Procedures:REMOVE SOURCES OF IGNITION. ABSORB SPILL
W/ABSORBENT MATERIAL SUCH AS VERMICULITE OR SAND.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:AVOID STORAGE ABOVE 100F. STORE ONLY
IN ORIGINIAL CONTAINERS.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Exposure Controls
Respiratory Protection:A NIOSH/MSHA APPROVED CANISTER TYPE RESPIRATOR
MUST BE WORN TO PREVENT THE INHALATION OF VAPORS OR SPRAY MISTS
WHEN THE TLV OR PEL IS EXCEEDED. WEAR A NIOSH/MSHA APPROVED DUST
MASK WHEN SANDING THE CU RED PRODUCT.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL &/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:PLASTIC/CHEMICAL RESISTANT GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:USE A BARRIER CREAM SUCH AS GLOVE COAT WHEN
USING THE PRODUCT.
Work Hygienic Practices:WASH HANDS BEFORE EATING & DO NOT SMOKE WHILE
USING. REMOVE & WASH CONTAMINATED CLOTHING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:SEE INGRED
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:1.797
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:PASTE; SHARP AROMATIC ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS & OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT & DIRECT SUNLIGHT.
Hazardous Decomposition Products:HEATING TO DECOMPOSITION MAY CAUSE
IRRITATING ACRID FUMES.
Conditions to Avoid Polymerization:IF HAZARDOUS POLYMERIZATION OCCURS
WHILE CONTAINED IN A CLOSED CONTAINER, VIOLENT RUPTURE MAY RESULT.
Disposal
Waste Disposal Methods:SMALL QUANTITIES CAN BE REACTED W/THE
APPROPRIATE HARDNER TO SOLIDIFY. DISPOSE OF IN ACCORDANCE W/ALL
FEDERAL, STATE & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.